.DT errors $MUDNAME$ creator help errors .SH Name .SI 5 errors - the command to handle error reports. .EI .SH Syntax .SI 5 errors .EI .SH Description .SP 5 5 This command is used to manipulate the ERROR_REPORTS files found in directories all over the place. .EP .SP 5 5 When run, the command will show the first report in the ERROR_REPORTS file that is in your current directory, at which time you have a lot of nice commands of which the most important is "d" which will remove the report from the file, and send mail to the one who reported the bug. .EP .SP 5 5 To edit the relevant file you can use the "e" command if the bug was reported correctly, or "e filename" if you have to edit some other file. .EP .SP 5 5 If you prefer to write your own comments, use the "d r" command which will take you to the editor. .EP .SP 5 5 If you can see the bugreport has been made incorrectly and really belongs in another dirctory, you can forward it with the "f" command. .EP .SP 5 5 To abort without sending any mail or changing the ERROR_REPORTS file you use "q". .EP .SP 5 5 To actually send the mails and finish you use "z". .EP .SH Commands .SO 5 10 -20 b b Post the error to board b. e Edit the file to correct the error. e f Edit file with name f. u Forward and delete error to unknow list. f n Forward and delete error to creator or directory n. d Delete bug and mark as fixed. d F same as above. d N Delete bug and mark as not an error. d R Delete bug and reply to sender yourself. The word $report$ will be replaced by the original bug report. n/+ Next error. p/- Previous error. g Goto to error. q Quit. x Save and quit. h/? This help file. .EO .SH Examples .SI 5 errors .EI .SH See also .SP 5 5 finderrors, printerrors .EP
